Today, Taiwei Diwei Machinery Equipment Co., Ltd., a manufacturer of plastic wire drawing machines, will introduce to you the methods for using and maintaining the wire drawing machine. The main function of the wire drawing machine is to process the copper wire into various specifications of thin wires. This equipment generally has impact load characteristics, and has the characteristics of large starting torque and low speed full torque output. In the system, multiple high-speed precision proportional linkage control is generally required, and the characteristics of the drive device require relatively high loads.
The use of wire drawing machine:
The equipment must be operated by personnel, special personnel maintenance, operating personnel should read the instruction manual carefully, familiar with the equipment performance and precautions.
Adjust the height of the table and press the stick according to the thickness and cutting amount of the workpiece being machined.
Observe its working condition every time the machine is started. It should be noted that the vacuum work can be terminated after the work is stopped.
To facilitate adjustment and improve work efficiency, the machine is equipped with both manual and automatic working conditions.
Require regular lubrication and maintenance of the machine tool.
Wire drawing machine maintenance:
Use clean compressed air to blow the machine. Pay attention to the cleanliness of the inner surface of the conveyor belt and the upper surface of the worktable. There must be no foreign matter on the surface of the sand mat and abrasive belt so as not to affect the sanding accuracy.
Regular sweeping and wiping of the belt swing control assembly, photocells and photoelectric switches to avoid inflexible belt oscillation.
The dust suction device should be activated when blowing the machine tool.
Check the compressed air filter regularly to remove condensate from the filter.
After 40 hours of work, check the pressure air filter and add enough lubricant.
After working for 200 hours, open the top cover of the base and apply grease on the worm gear to make it flexible
Check the tension and wear of narrow V-belts. Check the machine belt tension. Check the flatness of the table.
Check the wear of pneumatic brake pads (replace as necessary)
